Autonomous technology
Precision positioning. Repeatable missions.
Capabilities
What we're building toward.
- Under evaluation
PX4 compatibility
Open flight-control stack being evaluated for platform integration.
- Under evaluation
ArduPilot compatibility
Open flight-control stack being evaluated for platform integration.
- In development
RTK GNSS positioning
Carrier-phase corrections for centimetre-class positioning under good sky conditions.
- Under evaluation
LiDAR-based sensing
Range sensing for surface following and obstacle awareness.
- Design objective
Terrain-following missions
Holding height relative to the surface rather than the takeoff point.
- In development
Precision waypoint navigation
Repeatable routes for consistent coverage and change detection.
- In development
Grid-based flight planning
Generated serpentine passes with configurable spacing and headings.
- Under evaluation
Autonomous takeoff & landing
Automated launch and recovery within defined site conditions.
- Design objective
Pilot-assisted autonomy
The pilot supervises and can take control at any moment.
- Design objective
Pause & resume missions
Stop for a battery swap or refill and resume where the work left off.
- Design objective
Waypoint payload activation
Dispensing that starts and stops on planned segments of the route.
Roof application missions
Complex roofs. Consistent coverage.
- 01
Roof surface mapping
Build a surface model of the roof — slopes, ridges, parapets, curbs and equipment — before any application flight.
- 02
Flight-path generation
Generate passes across the mapped surface, respecting edges and exclusion zones around equipment.
- 03
Configurable pass spacing
Spacing matched to the nozzle pattern and the material's requirements. We're exploring passes roughly 2.5–3 ft apart as an engineering objective.
- 04
Roof-relative altitude
Hold a consistent height above the roof surface so the spray pattern stays consistent on pitched sections.
- 05
Obstacle awareness
Plan around known equipment, and sense what the plan missed.
- 06
Mission execution
Fly the plan with the pilot supervising, ready to take control.
- 07
Pause & resume
Save mission state at a pause so the next sortie continues without gaps or double coverage.
- 08
Controlled dispensing
Spray only on planned segments; transit legs and exclusion zones stay dry.
Terrain awareness
Height above the surface, not the ground.
Mission workflow
From survey to record.
- STEP 1
Survey
Site assessment, airspace check and roof mapping.
- STEP 2
Plan
Passes, spacing, altitude and exclusion zones generated and reviewed.
- STEP 3
Verify
Pre-flight checks of positioning fix, payload and plan.
- STEP 4
Execute
Supervised autonomous flight with controlled dispensing.
- STEP 5
Resume
Battery or refill stops resume from the saved state.
- STEP 6
Record
Flight and payload logs kept for quality records.
Autonomy assists a qualified remote pilot; it does not replace one. Operators remain responsible for FAA compliance (including 14 CFR Part 107 and any required waivers or authorizations), airspace restrictions and site safety. We make no safety guarantees for any mission profile.
Have a mission to automate?
Tell us about the site, the surface and the work. We'll tell you what's realistic.